中文版Vibrating disk to use debug instructions
First, the electronic control box receiving the 220v voltage, if the indicator does not light, check the electrical control box outside the fuse location, fuse is intact.
Second, the electronic control box receiving the 220v voltage, adjust speed control switch, whether the specified rotation to observe the vibration of disk speed, slowly getting faster, the vibration plate to reach the speed of your request more than 20% or more, if the voltage unstable, the vibration plate will appear when the fast slow phenomenon.
Third, the workpiece vibration plate can be put off by the size of the disk, such as the vibration plate when the workpiece does not cover the bottom of the plate, feeding immediately.
Fourth, the vibration plate in the workpiece speed rotary switch if in the end, the workpiece or the walk, please stop to see the chassis is defective.
There are three reasons:
1, check whether each spring break phenomenon:
2, the bolts are loose:
3, the spring need to re-adjust.
Solution
1, to replace the spring
2, tighten the bolts to
Method of adjusting spring: spring in each group select any one of the group, slightly less loose bolts, observe whether the rate of vibration of plate changes, fast you need to spring into thin, slow you need to spring into thick , the order method to adjust the vibration plate to the desired speed requirements.
(Note: for spring films must turn off the power electronic control box)
